NETGEAR M4100 Series ProSAFE

Quality of Service Commands
315
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch)# show auto-voip protocol-based interface all
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value.................................... 7
Interface Auto VoIP Operational Status
Mode
--------- -------------- ------------------
0/1 Disabled Down
0/2 Disabled Down
0/3 Disabled Down
0/4 Disabled Down
Command example:
(Netgear Switch)# show auto-voip oui-based interface all
VoIP VLAN Id................................... 2
Priority....................................... 7
Interface Auto VoIP Operational Status
Mode
--------- -------------- ------------------
0/1 Disabled Down
0/2 Disabled Down
0/3 Disabled Down
0/4 Disabled Down
0/5 Disabled Down
Class Value • If the Prioritization Type is configured as traffic-class, this value is the queue value.
• If the Prioritization Type is configured as remark, this value is 802.1p priority used
to remark the voice traffic.
Priority The 802.1p priority. This field is valid for OUI auto VoIP.
AutoVoIPMode The Auto VoIP mode on the interface.
Field Description