EasyManuals Logo

NETGEAR M4100 Series ProSAFE User Manual

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #557 background imageLoading...
Page #557 background image
Log Messages
557
M4100 Series ProSAFE Managed Switches
OSAPI osapiCleanupIf: NetIPGet During the call to remove the interface from
the route table, the attempt to get an ipv4
interface address from the stack failed.
OSAPI osapiCleanupIf: NetMaskGet During the call to remove the interface from
the route table ,the attempt to get the ipv4
interface mask from the stack failed.
OSAPI osapiCleanupIf: NetIpDel During the call to remove the interface from
the route table, the attempt to delete the
primary ipv4 address from the stack failed.
OSAPI osapiSemaTake failed The requested semaphore cannot be taken
because: the call is made from an ISR or
the semaphore ID is invalid.
Table 55. OSAPI Log Messages (continued)
Component Message Cause

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General IconGeneral
Product TypeManaged Switch
Form FactorRack-mountable
LayerLayer 2/Layer 3
ManagementWeb-based, CLI, SNMP
VLAN SupportYes
Quality of Service (QoS)Yes
Security FeaturesACLs, 802.1x
DimensionsVaries by model
WeightVaries by model
Operating Temperature32°F to 122°F (0°C to 50°C)
Storage Temperature-20° to 70° C (-4° to 158° F)
PoE SupportYes (on select models)

Related product manuals