NETGEAR M4100 Series ProSAFE

Quality of Service Commands
285
M4100 Series ProSAFE Managed Switches
police-two-rate
This command is the two-rate form of the police command and is used to establish the
traffic policing style for the specified class. For each outcome, the only possible actions are
drop, set-cos-as-sec-cos, set-cos-transmit, set-sec-cos-transmit, set-dscp-transmit,
set-prec-transmit, or transmit. In this two-rate form of the police command, the conform
action defaults to send, the exceed action defaults to drop, and the violate action defaults to
drop. These actions can be set with this command after the style is configured.
policy-map
This command establishes a new DiffServ policy. The <policyname> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the policy.
The type of policy is specific to the inbound traffic direction as indicated by the parameter
Note: The CLI mode is changed to Policy-Map Config when this command
is successfully executed.
Format police-simple {<1-4294967295> <1-128> conform-action {drop |
set-prec-transmit <0-7> | set-dscp-transmit <0-63> |
set-cos-transmit <0-7> | transmit} [violate-action {drop |
set-prec-transmit <0-7> | set-dscp-transmit <0-63> |
set-cos-transmit <0-7> | transmit}]}
Mode Policy-Class-Map Config
Incompatibilities Drop, Mark (all forms)
Format police-two-rate {<1-4294967295> <1-128> <1-4294967295> <1-128>
conform-action {drop | set-cos-as-sec-cos | set-cos-transmit <0-7>
| set-sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit} exceed-action {drop |
set-cos-as-sec-cos | set-cos-transmit <0-7> | set-sec-cos-transmit
<0-7> | set-prec-transmit <0-7> | set-dscp-transmit <0-63> |
transmit} violate-action {drop | set-cos-as-sec-cos |
set-cos-transmit <0-7> | set-sec-cos-transmit <0-7> |
set-prec-transmit <0-7> | set-dscp-transmit <0-63> | transmit}}
Mode Policy-Class-Map Config
Format policy-map <policyname> [in | out]
Mode Global Config