Quality of Service Commands
295
M4100 Series ProSAFE Managed Switches
ibmsna, ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, and
rarp. Each of these translates into its equivalent Ethertype value or values.
The time-range parameter allows imposing time limitation on the MAC ACL rule as
defined by the parameter <time-range-name>. If a time range with the specified name
does not exist and the MAC ACL containing this ACL rule is applied to an interface or bound
to a VLAN, then the ACL rule is applied immediately. If a time range with a specified name
exists and the MAC ACL containing this ACL rule is applied to an interface or bound to a
VLAN, then the ACL rule is applied when the time range with a specified name becomes
active. The ACL rule is removed when the time range with a specified name becomes
inactive.
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or
outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the
number of user configurable queues available for the hardware platform. The
assign-queue parameter is valid only for a permit rule.
Note: The special command form {deny | permit} any any is used to
match all Ethernet layer 2 packets, and is the equivalent of the IP
access list match every rule.
Ethertype Keyword Corresponding Value
appletalk 0x809B
arp 0x0806
ibmsna 0x80D5
ipv4 0x0800
ipv6 0x86DD
ipx 0x8037
mplsmcast 0x8848
mplsucast 0x8847
netbios 0x8191
novell 0x8137, 0x8138
pppoe 0x8863, 0x8864
rarp 0x8035
To Next Page
Loading...
