NETGEAR M4100 Series ProSAFE

Log Messages
545
M4100 Series ProSAFE Managed Switches
Table 27. 802.3ad Log Messages
Component Message Cause
802.3ad dot3adReceiveMachine: received default
event %x
Received a LAG PDU and the RX state
machine is ignoring this LAGPDU
802.3ad dot3adNimEventCompletionCallback,
dot3adNimEventCreateCompletionCallbac
k: DOT3AD: notification failed for
event(%d), intf(%d), reason(%d)
The event sent to NIM was not completed
successfully
Table 28. FDB Log Message
Component Message Cause
FDB fdbSetAddressAgingTimeOut: Failure
setting fid %d address aging timeout to %d
Unable to set the age time in the hardware
Table 29. Double VLAN Tag Log Message
Component Message Cause
Double Vlan Tag dvlantagIntfIsConfigurable: Error accessing
dvlantag config data for interface %d
A default configuration does not exist for
this interface. Typically a case when a new
interface is created and has no
pre-configuration.
Table 30. IPv6 Provisioning Log Message
Component Message Cause
IPV6
Provisioning
ipv6ProvIntfIsConfigurable: Error accessing
IPv6 Provisioning config data for interface
%d
A default configuration does not exist for
this interface. Typically a case when a new
interface is created and has no
pre-configuration.
Table 31. MFDB Log Message
Component Message Cause
MFDB mfdbTreeEntryUpdate: entry does not exist Trying to update a non-existing entry