EasyManuals Logo

NETGEAR M4100 Series ProSAFE User Manual

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #534 background imageLoading...
Page #534 background image
Log Messages
534
M4100 Series ProSAFE Managed Switches
Table 5. System Log Messages
Component Message Cause
SYSTEM Configuration file Switch CLI.cfg size is 0
(zero) bytes
The configuration file could not be read.
This message might occur on a system for
which no configuration has ever been
saved or for which configuration has been
erased.
SYSTEM could not separate
SYSAPI_CONFIG_FILENAME
The configuration file could not be read.
This message might occur on a system for
which no configuration has ever been
saved or for which configuration has been
erased.
SYSTEM Building defaults for file <file name> version
<version num>
Configuration did not exist or could not be
read for the specified feature or file.
Default configuration values will be used.
The file name and version are indicated.
SYSTEM File <filename>: same version (version
num) but the sizes (<version
size>-><expected version size) differ
The configuration file which was loaded
was of a different size than expected for the
version number. This message indicates
the configuration file needed to be migrated
to the version number appropriate for the
code image. This message might appear
after upgrading the code image to a more
current release.
SYSTEM Migrating config file <filename> from
version <version num> to <version num>
The configuration file identified was
migrated from a previous version number.
Both the old and new version number are
specified. This message might appear after
upgrading the code image to a more
current release.
SYSTEM Building Defaults Configuration did not exist or could not be
read for the specified feature. Default
configuration values will be used.
SYSTEM sysapiCfgFileGet failed size = <expected
size of file> version = <expected version>
Configuration did not exist or could not be
read for the specified feature. This
message is usually followed by a message
indicating that default configuration values
will be used.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General IconGeneral
Product TypeManaged Switch
Form FactorRack-mountable
LayerLayer 2/Layer 3
ManagementWeb-based, CLI, SNMP
VLAN SupportYes
Quality of Service (QoS)Yes
Security FeaturesACLs, 802.1x
DimensionsVaries by model
WeightVaries by model
Operating Temperature32°F to 122°F (0°C to 50°C)
Storage Temperature-20° to 70° C (-4° to 158° F)
PoE SupportYes (on select models)

Related product manuals