Log Messages
552
M4100 Series ProSAFE Managed Switches
Table 49. IGMP-Proxy Log Messages
Component Message Cause
IGMP-Proxy Error getting memory for igmp host group
record
When we are unable to allocate memory for
the IGMP group record in the Host (Proxy)
table
IGMP-Proxy Error getting memory for source record When we are unable to allocate memory for
the IGMP source record in the Host (Proxy)
table
Table 50. PIM-SM Log Messages
Component Message Cause
PIM-SM PIM-SM not initialized This message arises when trying to
activate pimsm interfaces or receiving
pimsm packets when pimsm component is
not initialized.
PIM-SM Unable to take xxx semaphore This message is logged when failed to
acquire semaphore to access source list or
group list or candidate Rp list or virtual
interface list. The xxx specifies the list for
which the access is denied.
PIM-SM Warning : Could not send packet type xxx
(pimsm packet type) on rtrIfNum
this warning is logged when failed to send a
pimsm control packet on the specified
router interface.
PIM-SM add_kernel_cache : memory allocation
failed
This message is logged when there is
insufficient memory to add a mroute entry
into cache.
PIM_SM Config error. Trying to add static RP.
Dynamic RP with same ip addr exists
Router learns RP-group mapping through
Bootstrap messages received.This
message pops when the static RP is
configured which conflicts the mapping
learnt dynamically through Bootstrap
messages.
PIM-SM Inner xxx(source/group) address of register
message is invalid
This log message appears when a register
message is received with invalid inner ip
source or group address.
To Next Page
Loading...
Need help?
General
