Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Quality of Service Commands

281

M4100 Series ProSAFE Managed Switches

Note: The only way to remove an individual policy attribute from a class

instance within a policy is to remove the class instance and re-add it

to the policy. The values associated with an existing policy attribute

can be changed without removing the class instance.

The CLI command root is policy-map.

assign-queue

This command modifies the queue id to which the associated traffic stream is assigned. The

<queueid> is an integer from 0 to n-1, where n is the number of egress queues supported

by the device.

drop

This command specifies that all packets for the associated traffic stream are to be dropped at

ingress.

mirror

This command specifies that all incoming packets for the associated traffic stream are copied

to a specific egress interface (physical port or LAG).

Format assign-queue <queueid>

Mode Policy-Class-Map Config

Incompatibilities Drop

Format drop

Mode Policy-Class-Map Config

Incompatibilities Assign Queue, Mark (all forms), Mirror, Police, Redirect

Format mirror <slot/port>

Mode Policy-Class-Map Config

Incompatibilities Drop, Redirect

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General