Utility Commands
383
M4100 Series ProSAFE Managed Switches
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured
pool name.
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation
of the media type and the MAC address.
For example, the Microsoft client identifier for Ethernet address c819.2488.f177 is
01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more information, refer
to the “Address Resolution Protocol Parameters” section of RFC 1700, Assigned Numbers
for a list of media type codes.
no client-identifier
This command deletes the client identifier.
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
Format no ip dhcp pool <name>
Mode Global Config
Default none
Format client-identifier <uniqueidentifier>
Mode DHCP Pool Config
Format no client-identifier
Mode DHCP Pool Config
Default none
Format client-name <name>
Mode DHCP Pool Config
To Next Page
Loading...
Need help?
General
