NETGEAR M4100 Series ProSAFE

Utility Commands
384
M4100 Series ProSAFE Managed Switches
no client-name
This command removes the client name.
default-router
This command specifies the default router list for a DHCP client.
<address1> and <address2>…<address8> must be valid IP addresses, each made up of
four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
no default-router
This command removes the default router list.
dns-server
This command specifies the IP servers available to a DHCP client. Address parameters are
valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
no dns-server
This command removes the DNS Server list.
Format
no client-name
Mode DHCP Pool Config
Default none
Format default-router <address1> [<address2>...<address8>]
Mode DHCP Pool Config
Format no default-router
Mode DHCP Pool Config
Default none
Format dns-server <address1> [<address2>...<address8>]
Mode DHCP Pool Config
Format no dns-server
Mode DHCP Pool Config