EasyManua.ls Logo

NETGEAR M4100 Series ProSAFE

NETGEAR M4100 Series ProSAFE
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Log Messages
554
M4100 Series ProSAFE Managed Switches
Technologies
Table 54. System General Error Messages
Component Message Cause
OS Invalid USP unit = x, slot = x, port =x A port was not able to be translated
correctly during the receive.
OS In hapiBroadSystemMacAddress call to
'bcm_l2_addr_add' - FAILED : x
Failed to add an L2 address to the MAC
table. This should only happen when a
hash collision occurs or the table is full.
OS Failed installing mirror action - rest of the
policy applied successfully
A previously configured probe port is not
being used in the policy. The release notes
state that only a single probe port can be
configured
OS Policy x does not contain rule x The rule was not added to the policy due to
a discrepancy in the rule count for this
specific policy . Additionally, the message
can be displayed when an old rule is being
modified, but the old rule is not in the policy
OS ERROR: policy x, tmpPolicy x, size x, data
x x x x x x x x
An issue installing the policy due to a
possible duplicate hash
OS ACL x not found in internal table Attempting to delete a non-existent ACL
OS ACL internal table overflow Attempting to add an ACL to a full table
OS In hapiBroadQosCosQueueConfig, Failed
to configure minimum bandwidth. Available
bandwidth x
Attempting to configure the bandwidth
beyond its capabilities
OS USL: failed to put sync response on queue A response to a sync request was not
enqueued. This could indicate that a
previous sync request was received after it
was timed out
OS USL: failed to sync ipmc table on unit=x Either the transport failed or the message
was dropped
OS usl_task_ipmc_msg_send(): failed to send
with x
Either the transport failed or the message
was dropped
OS USL: No available entries in the STG table The Spanning Tree Group table is full in
USL
OS USL: failed to sync stg table on unit=x Could not synchronize unit x due to a
transport failure or API issue on remote
unit. A synchronization retry will be issued
OS USL: A Trunk doesn't exist in USL Attempting to modify a Trunk that doesn’t
exist

Table of Contents

Related product manuals