B1.13 c10 registers
The processor can access different 32-bit wide system registers. Registers where CRn has the value ten
are called c10 registers.
The following table shows the 32-bit wide system registers you can access when the processor is in
AArch32 state and the value of CRn is c10.
Table B1-13 c10 register summary
Op1 CRm Op2 Name Reset Description
0 c2 0 PRRR UNK
B1.101 Primary Region Remap Register on page B1-322
0 MAIR0 UNK B1.95 Memory Attribute Indirection Registers 0 and 1 on page B1-310
1 NMRR UNK B1.99 Normal Memory Remap Register on page B1-319
1 MAIR1 UNK B1.95 Memory Attribute Indirection Registers 0 and 1 on page B1-310
c3 0 AMAIR0
0x00000000
B1.36 Auxiliary Memory Attribute Indirection Register 0 on page B1-198
1 AMAIR1
0x00000000
B1.37 Auxiliary Memory Attribute Indirection Register 1 on page B1-199
4 c2 0 HMAIR0 UNK
Hyp Memory Attribute Indirection Register 0
See the Arm
®
Architecture Reference Manual Armv8, for Armv8-A architecture
profile for more information.
1 HMAIR1 UNK
Hyp Memory Attribute Indirection Register 1
See the Arm
®
Architecture Reference Manual Armv8, for Armv8-A architecture
profile for more information.
c3 0 HAMAIR0
0x00000000
B1.58 Hyp Auxiliary Memory Attribute Indirection Register 0 on page B1-235
1 HAMAIR1
0x00000000
B1.59 Hyp Auxiliary Memory Attribute Indirection Register 1 on page B1-236
B1 AArch32 system registers
B1.13 c10 registers
100236_0100_00_en Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
B1-168
Non-Confidential
To Next Page
Loading...
Need help?
General
