ARM Cortex-A35 User Manual

B2.36 CPU Auxiliary Control Register, EL1
The CPUACTLR_EL1 characteristics are:
Purpose
Provides IMPLEMENTATION DEFINED configuration and control options for the processor. There is
one 64-bit CPU Auxiliary Control Register for each core in the processor.
Usage constraints
This register is accessible as follows:
EL0
EL1
(NS)
EL1
(S)
EL2
EL3
(SCR.NS = 1)
EL3
(SCR.NS = 0)
- RW RW RW RW RW
The CPU Auxiliary Control Register can be written only when the system is idle. Arm
recommends that you write to this register after a powerup reset, before the MMU is enabled,
and before any master interface or ACP traffic begins.
Setting many of these bits can cause significantly lower performance on your code. Therefore, it
is suggested that you do not modify this register unless directed by Arm.
Configurations
CPUACTLR_EL1 is:
• Common to the Secure and Non-secure states.
• Mapped to the AArch32 CPUACTLR register. B1.42 CPU Auxiliary Control Register
on page B1-208.
Attributes
CPUACTLR_EL1 is a 64-bit register.
31 22 18 17 091011121315161920212829
RES0
DIDIS
RES0
L1PCTL
L1RADIS
RADIS
NPFSTRM
DSTDIS
STRIDE
63
CDIDIS
30 2324
STBPFDISSTBPFRS
27 26 25
DTAH
RES0
ENDCCASCI
45 44 43 7
RES0
6 5
DODMBS
L1DEIEN
RES0
RES0
DYNSDIS
Figure B2-11 CPUACTLR_EL1 bit assignments
[63:45]
Reserved, RES0.
ENDCCASCI, [44]
Enable data cache clean as data cache clean/invalidate. The possible values are:
0 Normal behavior, data cache clean operations are unaffected. This is the reset value.
B2 AArch64 system registers
B2.36 CPU Auxiliary Control Register, EL1
100236_0100_00_en Copyright © 2015–2017, 2019 Arm Limited or its affiliates. All rights
reserved.
B2-412
Non-Confidential

ARM Cortex-A35 Specifications

General

Brand	ARM
Model	Cortex-A35
Category	Computer Hardware
Language	English