Lexmark C950 - Sensor (Booklet Knife HP) Lag Jam

Diagnostic information 2-173
5058-030
Go Back
Previous
Next
381.38 Sensor (booklet knife HP) lag jam
9
Is the booklet folding/exit drive
motor assembly properly
connected?
Replace the booklet folding/exit
drive motor assembly. Go to
“Booklet folding/exit drive
motor assembly removal” on
page 4-254.
Replace the connection.
10
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the booklet controller
card assembly. Go to “Booklet
controller card assembly
removal” on page 4-250.
Problem resolved
11
Perform a POR.
Does the error continue when
the power is turned off/on?
Replace the finisher PCBA. Go to
“Finisher PCBA removal” on
page 4-281.
Problem resolved
Step Action and questions Yes No
1 Check the booklet unit interface
connector assembly.
Is the above component free of
damage?
Go to step 2. Replace the booklet unit interface
contact.
2
Check the main connector on the
booklet unit sensor interface
cable assembly.
Is the above component free of
damage?
Go to step 3. Replace the booklet sensor
interface cable assembly.
3
Check the main connector on the
booklet unit motor interface cable
assembly.
Is the above component free of
damage?
Go to step 4. Replace the booklet motor
interface cable assembly.
4
Check the sensor (booklet knife
HP) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (booklet knife
HP).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 6. Go to step 5.
5
Is the sensor (booklet knife HP)
properly connected?
Replace the sensor (booklet knife
HP). Go to
“Sensor (booklet
knife HP) removal” on
page 4-314.
Replace the connection.
Step Action and questions Yes No