Lexmark C950 - Finisher Media Entrance Roll Assembly Removal

4-280 Service Manual
5058-030
Go Back
Previous
Next
3. Remove the two screws securing the finisher LVPS PCBA (A) to the finisher.
4. Remove the finisher LVPS PCBA (A).
Finisher media entrance roll assembly removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-276.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
3. Remove the left upper cover. See “Left upper cover removal” on page 4-289.
4. Remove the punch waste box (A) from the finisher.
5. Remove the screw securing the cover (B) to the media entrance pinch guide assembly.
6. Remove the cover (B).
7. Lift the media entrance pinch guide assembly (C).
8. Loosen the two screws securing the belt tensioner bracket (D) to the finisher and move it upward in the
direction of the arrow.
9. Remove the belt (entrance/paddle) (E) from the entrance drive pulley 20T (F).
10. Release the hook securing the entrance drive gear 23T (G) to the media entrance roll assembly (H).
11. Remove the entrance drive gear 23T (G).
Rear
A
First
Second
D
E
D
C
B
A
Front