Lexmark C950 - Booklet Paddle Drive Motor Assembly Removal; Booklet Rear Tamper Guide Removal

Repair information 4-259
5058-030
Go Back
Previous
Next
Booklet paddle drive motor assembly removal
1. Remove the booklet unit chassis. See “Booklet unit chassis removal” on page 4-263.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-262.
3. Disconnect the connectors from the booklet paddle drive motor assembly (A).
4. Remove the two screws securing the booklet paddle drive motor assembly (A) from the compiler frame.
5. Remove booklet paddle drive motor assembly (A).
Booklet rear tamper guide removal
1. Remove the booklet unit chassis. See “Booklet unit chassis removal” on page 4-263.
2. Remove the booklet unit motor assembly. See “Booklet folding/exit drive motor assembly removal”
on page 4-254.
3. Remove the knife solenoid frame. See “Booklet fold solenoid frame removal” on page 4-253.
4. Remove the booklet media entrance drive motor. See “Booklet media entrance drive motor removal”
on page 4-257.
5. Remove the booklet knife sector drive gear 42T. See “Booklet knife sector drive gear 42T removal” on
page 4-256.
6. Remove booklet unit gear train frame. See “Booklet unit gear train frame removal” on page 4-264.
7. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-262.
8. Remove the screw (A) securing the sensor (booklet rear tamper HP).
9. Slide the booklet rear tamper guide out.
10. Remove the e-clip.
11. Remove the two springs (B) from the booklet rear tamper guide.
12. Remove booklet rear tamper guide.
Left
Connector
A