Lexmark C950 - Sensor (Media Level) Removal; Sensor (Media Out) Removal

Repair information 4-197
5058-030
Go Back
Previous
Next
Sensor (media level) removal
This removal procedure applies to trays 1–4.
1. Remove the appropriate feeder unit. See “Printer tray 1 feeder removal” on page 4-138, “Tray module
media feeder removal” on page 4-208, “TTM tray 4 media feeder removal” on page 4-221, or “TTM
tray 3 feeder removal” on page 4-217.
2. Release the tabs (A) securing the sensor (media level) to the assembly.
3. Remove the sensor (media level).
4. Disconnect the harness (B).
Sensor (media out) removal
This removal procedure applies to trays 1–4.
1. Remove the appropriate feeder unit. See “Printer tray 1 feeder removal” on page 4-138, “Tray module
media feeder removal” on page 4-208, “TTM tray 4 media feeder removal” on page 4-221, or “TTM
tray 3 feeder removal” on page 4-217.
2. Remove the media out actuator. See “Media out actuator removal” on page 4-117.
3. Release the tab (A) securing the sensor (media out) to the assembly.
4. Remove the sensor (media out).