Lexmark C950 - Sensor (TTM Media Size) Removal; Sensor (TTM Tray 3 Feedout) Removal

Repair information 4-203
5058-030
Go Back
Previous
Next
Sensor (TTM media size) removal
This removal procedure can be applied to either TTM tray 3 media tray or TTM tray 4 media tray.
1. Pull the appropriate TTM media tray from the machine.
2. Remove the screw (A).
3. Disconnect the cable (B).
4. Remove the sensor (TTM media size).
Sensor (TTM tray 3 feedout) removal
1. Open the left door.
2. Remove the lower tray module media transport roller. See “Tray module transport rollers removal” on
page 4-213.