Lexmark C950 - Sensor (Finisher Media Entrance) Removal

4-320 Service Manual
5058-030
Go Back
Previous
Next
8. Remove the two screws securing the bracket (A) to the finisher.
9. Remove the bracket (A).
10. Disconnect the connector from the sensor (diverter gate) (B).
11. Remove the screw securing the sensor (diverter gate) (B) to the bracket (A).
12. Remove the sensor (diverter gate) (B).
Sensor (finisher media entrance) removal
1. Open the front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
3. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-352.
4. Remove the top cover. See “Top cover removal” on page 4-351.
5. Remove the left lower cover. See “Left lower cover removal” on page 4-288.
6. Remove the left upper cover. See “Left upper cover removal” on page 4-289.
7. Disconnect the connector from the sensor (finisher media entrance) (A).
B
Left
A
Connector