3-24 Service Manual
5058-030
FINISHER SENSOR TESTS
This test verifies that the sensors in the finisher are operating properly.
To run these tests:
1. From the Diagnostics Menu, navigate to SENSOR TESTS.
2. Select FINISHER SENSOR TESTS.
3. Select the test from the following options:
• Sensor (tray 1 media out) • Sensor (fuser exit)
• Sensor (tray 1 media level) • Sensor (paper on belt)
• Sensor (tray 1 media size switch) • Sensor (registration)
• Sensor (tray 1 pre feed) • Sensor (MPF feed out)
• Sensor (tray 2 media out) • Sensor (duplex wait)
• Sensor (tray 2 media level) • Sensor (lower redrive shift HP)
• Sensor (tray 2 feed out) • Sensor (upper redrive shift HP)
• Sensor (tray 2 media size) • Sensor (standard bin 1 media full)
• Sensor (tray 3 media out) • Sensor (standard bin 2 media full)
• Sensor (tray 3 media level) • Sensor (printer left door interlock)
• Sensor (tray 3 feed out) • Sensor (upper redrive door interlock)
• Sensor (tray 3 media size) • Sensor (printer front door interlock)
• Sensor (tray 3 pre feed) TTM only • Sensor (duplex door interlock)
• Sensor (tray 4 media out) • Sensor (tray module left door interlock)
• Sensor (tray 4 media level) • Sensor (waste toner bottle present)
• Sensor (tray 4 feed out) • Sensor (waste toner bottle full)
• Sensor (tray 4 media size) • Sensor (1st transfer rolls retract HP)
• Sensor (tray 4 pre feed) TTM only • Sensor (2nd transfer roll retract HP)
• Sensor (MPF media out)
Available tests:
• Sensor (booklet knife HP) • Sensor (rear tamper HP)
• Sensor (booklet compiler media
present)
• Sensor (stapler carriage HP)
• Sensor (booklet media exit) • Sensor (staple low)
• Sensor (booklet unit interlock) • Sensor (staple self priming)
• Sensor (booklet front staple low) • Sensor (staple motor HP)
• Sensor (booklet rear staple low) • Sensor (media eject clamp HP)
• Sensor (booklet bin media present) • Sensor (media eject shaft HP)
• Sensor (booklet front tamper HP) • Sensor (stacker bin upper limit)
• Sensor (booklet media entracne) • Sensor (stacker bin no media)
• Sensor (booklet rear tamper HP) • Sensor (stacker bin level encoder)
• Sensor (booklet end guide HP) • Sensor (stacker bin level 1)
• Sensor (booklet knife folding) • Sensor (stacker bin level 2)
• Sensor (finisher media entrance) • Sensor (punch carriage shift HP)
• Sensor (buffer path) • Sensor (punch cam HP)
Available tests:
To Next Page
Loading...
