Lexmark C950 - Sensor (Diverter Gate) Late Jam

2-186 Service Manual
5058-030
Go Back
Previous
Next
482.03 Sensor (diverter gate) late jam
4
Check the finisher PCBA for
proper connection.
Is the above component
properly connected?
Go to Step 5. Replace the connections.
5
POR the machine.
Does the error continue?
Replace the finisher PCBA.
Go to “Finisher PCBA removal”
on page 4-281.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the sensor (diverter gate)
for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (diverter
gate).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 4. Go to step 3.
3
Check the sensor (diverter gate)
for proper connection.
Is the above component
properly connected?
Replace the sensor (diverter
gate)
Go to “Sensor (diverter gate)
removal” on page 4-319.
Replace the connections.
4
Check the buffer/transport
stepper motor for proper
operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Buffer/transport
motor.
Does the above component
operate properly?
Go to step 6. Go to step 5.
Step Action and questions Yes No