Lexmark C950 - Clamp Drive Motor Removal

4-268 Service Manual
5058-030
Go Back
Previous
Next
6. Move the buffer pinch guide assembly (A) to the right to remove the two bosses from the holes in the
finisher.
Clamp drive motor removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
2. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-352.
3. Remove the two media eject unit springs (A) attached to the media eject unit assembly (B) by pushing
them downward.
Hole in rear frame
Boss
A
Right
A
B