2-178 Service Manual
5058-030
401.03 Sensor (bridge media entrance) late jam
5
Perform a print test. Go to
“PRINT TESTS” on page 3-22.
Does the error remain?
Replace the finisher PCBA.
Go to “Finisher PCBA removal”
on page 4-281.
Problem resolved
Step Action and questions Yes No
1 Check the media path.
Is the media path free of any
media fragments?
Go to step 2. Remove any media or media
fragments.
2
Check the bridge unit media
transport rollers.
Are the bridge unit media
transport rollers free of excess
wear and contamination?
Go to step 3. Clean or replace the bridge unit
assembly.
Go to “Bridge unit assembly
removal” on page 4-232.
3
Check the sensor (bridge media
entrance) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (bridge media
entrance).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 5. Go to step 4.
4
Check the sensor (bridge media
entrance) for proper connection.
Is the above sensor properly
connected?
Replace the sensor (bridge
media entrance).
Go to “Sensor (bridge media
entrance) removal” on
page 4-240.
Replace the connection.
5
Check the bridge drive motor for
proper operation.
Caution: When
performing motor
tests, ensure that all
cover and door
interlock switches
are overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Bridge unit motor.
Does the above component
operate properly?
Go to step 7. Go to step 6.
Step Action and questions Yes No
To Next Page
Loading...
