Repair information 4-105
5058-030
19. Remove the drive belt.
Re-installation tip: To make the reinstallation of the lower redrive shift motor assembly easier, ensure that the
drive belt is placed on the lower redrive shift motor assembly drive pulley and that the plastic motor cover is
attached to the lower redrive shift motor assembly as you reattach it to the machine. This will prevent the drive
belt from slipping. After you have reattached the lower redrive shift motor assembly to the machine, you will
need to remove the plastic motor cover to replace both screws, and then reattach the motor cover.
LVPS front fan guide removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-16.
2. Remove the rear lower cover. See “Rear lower cover removal” on page 4-14.
3. Remove the printer right over. See “Printer right cover removal” on page 4-11.
4. Remove the two screws (A) securing the LVPS front fan guide to the machine.
To Next Page
Loading...
