Lexmark C950 - Sensor (Media Out) Removal

4-150 Service Manual
5058-030
Go Back
Previous
Next
3. Disconnect the cable (B).
4. Remove the sensor (media on belt).
Sensor (media out) removal
1. Remove the appropriate feeder unit. See “Printer tray 1 feeder removal” on page 4-138, “Tray module
media feeder removal” on page 4-208, “TTM tray 4 media feeder removal” on page 4-221, or “TTM
tray 3 feeder removal” on page 4-217.
2. Remove the media out actuator. See “Media out actuator removal” on page 4-117.
3. Release the tab (A) securing the sensor (media out) to the assembly.