Lexmark C950 - Sensor (Image Calibration) Removal

Repair information 4-147
5058-030
Go Back
Previous
Next
number of applications or settings may exceed the file size limit and have information truncated in the
exported file.
Sensor (image calibration) removal
1. Remove the printer front door. See “Printer front door removal” on page 4-10.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-172.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel front cover.
7. Remove the printhead retract door. See “Printhead retract door removal” on page 4-139.
8. Remove the inner cover. See “Inner cover removal” on page 4-3.
9. Remove the inner plate. See “Inner plate removal” on page 4-92.
10. Remove the waste toner add chute. See “Waste toner auger chute removal” on page 4-188.
11. Remove the front left cooling fan. See “Front left cooling fan removal” on page 4-72.
12. Disconnect the cable (A) from the sensor (image calibration).
13. Remove the screw (B) from the sensor (image calibration).
BA