2-206 Service Manual
5058-030
493.05 Sensor (booklet media exit) lag jam
7
Check the finisher controller card
assembly for proper connection.
Is the above component
properly connected?
Go to step 8. Replace the connections.
8
POR the machine.
Does the error continue?
Replace the finisher controller
card assembly.
Go to “Finisher PCBA removal”
on page 4-281.
Problem resolved
Step Action and questions Yes No
1 Check the sensor (booklet media
exit) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (booklet
media exit).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 3. Go to step 2.
2
Check the sensor (booklet media
exit) for proper connection.
Is the above component
properly connected?
Replace the sensor (booklet
media exit).
Go to “Sensor (booklet unit
media exit) removal” on
page 4-317.
Replace connections.
3
Check the booklet folding/exit
motor for proper operation.
When performing
motor tests, ensure
that all cover and
door interlock
switches are
overridden.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch FINISHER MOTOR
TESTS.
4. Touch Booklet folding/exit
motor (forward).
5. Touch Booklet folding/exit
motor (reverse).
Does the above component
operate properly?
Go to step 5. Go to step 4.
Step Action and questions Yes No
To Next Page
Loading...
