Diagnostic aids 3-5
5058-030
Configuration Menu
Entering Configuration Menu
1. Turn off the printer.
2. Press and hold the 2 and 6 buttons simultaneously.
3. Turn on the printer.
4. Release the buttons after 10 seconds.
Available settings
Settings appear on the LCD in the order shown:
Reset Maintenance Counter
See “Reset Maintenance Counter Value” on page 3-11.
REGISTRATION
See “REGISTRATION” on page 3-10.
Black Only Mode
See “Black Only Mode” on page 3-7.
Print Quality Pages
See “Print Quality Pages” on page 3-10.
Reports
See “Reports” on page 3-11.
Color Trapping
See “Color Trapping” on page 3-7.
Tray Insert Msg
See “Tray Insert Message Delay” on page 3-12.
SIZE SENSING
See “Size Sensing” on page 3-12.
Exit Tray 2
See “Exit Tray 2” on page 3-8.
Panel Menus
See “Panel Menus” on page 3-10.
PPDS Emulation
See “PPDS Emulation” on page 3-10.
Download Emuls
Factory Defaults
See “Factory Defaults” on page 3-8.
Energy Conserve
See “Energy Conserve” on page 3-8.
Auto Align Adj
See “Automatic Alignment Adjust Calibration” on
page 3-6.
Paper Prompts
See “Paper Prompts” on page 3-10.
Envelope Prompts
See “Envelope Prompts” on page 3-8.
Action for Prompts
See “Action for prompts” on page 3-6.
Jobs On Disk
See “Jobs on Disk” on page 3-9.
Disk Encryption
See “Disk Encryption” on page 3-7.
Erase All Information on Disk
See “Erase all Information on Disk” on page 3-8.
Wipe All Settings
See “Wipe All Settings” on page 3-13.
Font Sharpening
See “Font Sharpening” on page 3-9.
Require Standby
See “Require Standby” on page 3-11.
Short-edge Printing
See “Short-edge Printing” on page 3-11.
To Next Page
Loading...
