Lexmark C950 - ATC Sensor PCB Bracket Removal

Repair information 4-25
5058-030
Go Back
Previous
Next
ATC sensor PCB bracket removal
1. Remove the printer front door. See “Printer front door removal” on page 4-10.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-172.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel front cover.
7. Remove the printhead retract door. See “Printhead retract door removal” on page 4-139.
8. Remove the inner cover. See “Inner cover removal” on page 4-3.
9. Remove the two screws from the ATC sensor PCB bracket (A).
10. Disconnect the five cables (B) from the ATC sensor PCB bracket.
A
B