Lexmark C950 - Clamp Paddle Removal

Repair information 4-269
5058-030
Go Back
Previous
Next
4. Disconnect the connector from the media eject clamp motor (C).
5. Disconnect the connector from the sensor (media eject clamp HP) (D).
6. Remove the three screws securing the bracket (E) to the finisher.
7. Remove the bracket (E).
Note: When removing the bracket, turn the media eject clamp gear 70T (F) so that it does not interact with
the sensor (media eject clamp HP) (D).
8. Remove the two screws securing the media eject clamp motor to the bracket (E).
9. Remove the media eject clamp motor (C).
Reinstallation note: When replacing the bracket, turn the media eject clamp gear 70T (F) so that it interacts
with the sensor (media eject clamp HP).
Clamp paddle removal
1. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-276.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
3. Remove the media eject shaft assembly. See “Eject roll shaft removal” on page 4-270.
Rear
E
C
D
F
Connector