Lexmark C950 - TTM Tray 3 Feeder Removal

Repair information 4-217
5058-030
Go Back
Previous
Next
4. Remove the two screws (C) securing the TTM lower transport motor to the machine.
Note: When removing the TTM lower transport motor, the drive belt will become detached.
5. Remove the TTM lower transport motor.
Reinstallation note: To correctly set the drive belt tension, install the TTM lower transport motor and the TTM
lower transport motor tension spring before completely tightening the three screws.
TTM tray 3 feeder removal
1. Remove the TTM tray 3 media tray out from the machine. See “TTM tray 3 media tray removal” on
page 4-220.
2. Pull open, but do not remove, the TTM tray 4 media tray.
3. Open the left door.