3-90 Service Manual
5058-030
• Rear staple (corner) [rear corner]
This type of stapling is applied for media with a width of 216 mm or more.
The stapler moves to the rear corner and staples a set of media obliquely (45
degrees) after the front tamper aligns the media to the rear side.
• Rear Staple (Straight) [rear straight]
This type of stapling is applied for media with a width of less than 216 mm.
The Stapler staples a set of media in parallel with the media edge after the front
tamper aligns the media to the rear side.
• Dual Staple [dual]
The Stapler staples a set of media at fixed positions (front/rear sides) in parallel
with the media edge after the front tamper aligns the media to the specified position
for each media size.
Media sizes that allow stapling
Media size that allows stapling depends on stapling positions.
The following table shows media sizes and the applicability of stapling for each staple position.
Front
corner
Rear
corner
Rear
straight
Dual
A3 SEF Yes Yes No Yes
A4 LEF Yes Yes No Yes
11 x 17 in. SEF Yes Yes No Yes
8.5 x 11 in. LEF Yes Yes No Yes
8K SEF(GCO), 16K LEF(GCO) Yes Yes No Yes
B4 SEF, B5 LEF Yes Yes No Yes
8 x 10 in. LEF Yes Yes No Yes
8.5 x 14 in. SEF / 8.5 x 13 in. SEF /
8.5 x 11 in. SEF
Yes No Yes Yes
A4 SEF Yes No Yes Yes
8 x 10 in. SEF Yes No Yes Yes
Yes: Applicable, No: Not applicable
Front
Rear
Process direction
Front
Rear
Process direction
Front
Rear
Process direction
To Next Page
Loading...
