Diagnostic information 2-41
5058-030
115.09 Multiple LED printhead write failure
115.10 Single LED printhead write failure
4
POR the machine.
Does the error continue?
Replace the lower engine PCBA .
Go to “Lower engine PCBA
removal” on page 4-98.
Go to step 5.
Problem resolved
5
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-181.
Problem resolved
Step Action and questions Yes No
1 Check the LED printhead for
proper connections.
Is the above component
properly connected?
Go to step 2. Replace the connections.
2
Replace the printhead interface
contact.
Does the error remain?
Go to step 3. Problem resolved
3
POR the machine.
Does the error continue?
Replace the lower engine PCBA.
Go to “Lower engine PCBA
removal” on page 4-98.
Go to step 4.
Problem resolved
4
POR the machine.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-181.
Problem resolved
Step Action and questions Yes No
1 Check the LED printhead for
proper installation.
Is the LED Printhead properly
installed?
Go to step 2. Install the LED printhead
properly.
2
Check the LED printhead for
proper connections.
Is the above component
properly connected?
Go to step 3. Replace the connections.
3
Replace the printhead flat data
cable
Does the error remain?
Go to step 4. Problem resolved
Step Action and questions Yes No
To Next Page
Loading...
Need help?
General
