Lexmark C950 - Sensor (Booklet Rear Tamper HP) Removal; Sensor (Booklet Unit Interlock) Removal

4-316 Service Manual
5058-030
Go Back
Previous
Next
Sensor (booklet rear tamper HP) removal
1. Remove the booklet unit assembly. See “Booklet unit chassis removal” on page 4-263.
2. Remove the booklet unit assembly left cover. See “Booklet unit assembly left cover removal” on
page 4-262.
3. Disconnect the connector from the booklet left tamper sensor.
4. Remove the screw securing the sensor (booklet rear tamper HP) bracket from the booklet unit assembly.
5. Remove sensor (booklet rear tamper HP) (A).
Sensor (booklet unit interlock) removal
1. Open the finisher front door assembly.
2. Pull the booklet unit assembly out of the finisher.
3. Remove rear lower cover. See “Upper media bin front cover removal” on page 4-353.
A
Connector
Left