2-24 Service Manual
5058-030
250.05
Paper jam
Sensor (MPF feed out) lag jam The media reached the sensor (MPF feed
out) but did not clear it within the specified
time.
Go to “250.05 Sensor (MPF feed out) lag
jam” on page 2-125.
250.06
Paper jam
Sensor (MPF feed out) failed to pick
jam
The media is late reaching the sensor
(MPF feed out) within the specified time
after the feed from the MPF has started.
Go to “250.06 Sensor (MPF feed out)
late jam” on page 2-129.
250.56
Paper jam
Sensor (MPF feed out) late jam
80K interval for feed rollers exceeded
in tray 3.
The media is late reaching the sensor
(MPF feed out) within the specified time
after the feed from tray 4 has started.
Go to “250.56 Sensor (MPF feed out)
late jam (80K interval exceeded for feed
rolls)” on page 2-130.
3xx service errors
Error code Description Action
324.xx
Service finisher error
Tray 2 lift motor failure The Tray 2 lift motor did not raise to the
appropriate position.
Go to “324.xx Tray 2 lift motor failure”
on page 2-133.
334.xx
Service finisher error
Tray 3 lift motor failure The Tray 3 lift motor did not raise to the
appropriate position.
Go to “334.xx Tray 3 lift motor failure”
on page 2-134.
344.xx
Service finisher error
Tray 4 lift motor failure The Tray 4 lift motor did not raise to the
appropriate position.
Go to “344.xx Tray 4 lift motor failure”
on page 2-135.
354.xx
Service finisher error
Tray 5 lift motor failure The Tray 5 lift motor did not raise to the
appropriate position.
Go to “354.xx Tray 5 lift motor failure”
on page 2-136.
381.01
Service finisher error
Sensor (booklet front tamper HP) late
error
The sensor (booklet front tamper HP) did
not activate within the specified time.
Go to “381.01 Sensor (front tamper HP)
late jam” on page 2-131.
381.02
Service finisher error
Sensor (front tamper HP) lag error The sensor (front tamper HP) activated,
but did not clear it within the specified time.
Go to “381.02 Sensor (front tamper HP)
lag jam” on page 2-137.
2xx service error codes
Error code Description Action