Lexmark C950 - Developer Housing Rear Plunger Removal

Repair information 4-67
5058-030
Go Back
Previous
Next
• Move the appropriate wiper in and out to clean the printhead.
Developer housing rear plunger removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-16.
2. Remove the PC/developer drive motor. See “PC/developer drive motor removal” on page 4-132.
1. Remove the operator panel left cover.
2. Remove the operator panel right cover.
3. Remove the operator panel front cover.
4. Remove the top cover. See “Printer top cover removal” on page 4-12.
5. Remove the printer front door. See “Printer front door removal” on page 4-10.
6. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-172.
7. Remove the waste toner box.
8. Remove the four photoconductor units.
9. Remove the four toner supplies.
10. Remove the printhead retract door. See “Printhead retract door removal” on page 4-139.
11. Remove the CMYK toner dispense auger assembly. See “CMYK toner dispense auger assembly
removal” on page 4-37.