Lexmark C950 - Switch (Eject Cover Interlock) Removal; Switch (Finisher Front Door Interlock) Removal

4-350 Service Manual
5058-030
Go Back
Previous
Next
Switch (eject cover interlock) removal
1. Remove the upper media bin assembly. See “Upper media bin assembly removal” on page 4-352.
2. Disconnect the connector from the switch (eject cover interlock) (A).
3. Release the harness from the two clamps.
4. Remove the screw securing the bracket (B) to the finisher.
5. Remove the bracket (B) from the square hole in the finisher.
6. Remove the two screws securing the switch (eject cover interlock) (A) from the bracket (B).
7. Remove the switch (eject cover interlock) (A).
Reinstallation note: Make sure the media eject unit assembly (C) properly actuates the switch (media eject
interlock) (A) without binding.
Switch (finisher front door interlock) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
3. Remove the punch waste box (A).
4. Remove the three screws in the front securing the punch waste chute (B).
5. Gently pull down the punch waste chute (B) to gain better access to the switch (finisher front door
interlock)
(C).
Right
A
B
Clamp
Clamps
Connector
A
C