Lexmark C950 - Booklet Fold Solenoid Frame Removal; Booklet Fold Solenoid Removal

Repair information 4-253
5058-030
Go Back
Previous
Next
Booklet fold solenoid frame removal
1. Remove the booklet unit chassis. See “Booklet unit chassis removal” on page 4-263.
2. Remove the booklet unit motor assembly. See “Booklet folding/exit drive motor assembly removal”
on page 4-254.
3. Disconnect the connectors from the booklet fold solenoid (A).
4. Remove the spring from the booklet fold solenoid frame (A).
5. Remove the five screws securing the booklet gear train frame from the booklet unit chassis.
6. Remove the two e-clips from shaft X & Y.
7. Remove the two bushings from shaft X & Y.
8. Remove the folding solenoid frame (A).
Booklet fold solenoid removal
1. Remove the booklet unit chassis. See “Booklet unit chassis removal” on page 4-263.
2. Remove the booklet unit motor assembly. See “Booklet folding/exit drive motor assembly removal”
on page 4-254.
3. Remove the knife solenoid frame. See “Booklet fold solenoid frame removal” on page 4-253.
4. Remove the screw securing the booklet fold solenoid from the booklet fold solenoid frame (A).
A
B
C
D
Rear