4-250 Service Manual
5058-030
5. Remove booklet bin hookup cable assembly (A).
Booklet controller card assembly removal
Warning: When replacing the booklet controller card assembly, the existing booklet maker adjustments must
be restored to the original settings, or booklet folding and stapling will be out of alignment. The
existing booklet maker adjustments can be found on the settings sheet located in the tray 1 settings
sheet compartment.
To enter replacement settings or if the setting sheet is not available, refer to booklet maker setup and
adjustment located in chapter 4. See
“High capacity feeder (HCF) removals” on page 4-359.
1. Remove the rear lower cover. “Upper media bin front cover removal” on page 4-353.
2. Loosen the four screws securing the plate to the finisher.
3. Move the plate to the right and outward.
4. Remove the plate.
5. Disconnect the connectors from the booklet controller card assembly (A).
To Next Page
Loading...
