Lexmark C950 - HCF Transport Motor Removal; HCF Transport Roller Kit Removal

4-380 Service Manual
5058-030
Go Back
Previous
Next
HCF transport motor removal
1. Remove the HCF unit from the printer.
2. Remove the HCF rear cover. See “HCF rear cover removal” on page 4-371.
3. Disconnect the connector from the HCF transport motor (A).
4. Release the harness from the clamp.
5. Remove the three screws securing the HCF transport motor (A) to the unit.
6. Remove the HCF transport motor (A).
HCF transport roller kit removal
1. Remove the HCF unit from the printer.
2. Use needle nose pliers to remove the e-clip on the front side securing the HCF transport roller kit (A) to the
unit.
A
Harness clamp
Connector