Lexmark C950 - Waste Toner Auger Chute Removal

4-188 Service Manual
5058-030
Go Back
Previous
Next
15. Remove the three screws (H) securing the waste toner agitator motor to the machine.
16. Remove the waste toner agitator motor.
Waste toner auger chute removal
1. Remove the printer front door. See “Printer front door removal” on page 4-10.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-172.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel left cover.
7. Remove the operator panel right cover.
8. Remove the operator panel front cover.
9. Remove the printhead retract door. See “Printhead retract door removal” on page 4-139.
10. Remove the inner cover. See “Inner cover removal” on page 4-3.
11. Remove the ATC sensor PCB bracket. See “ATC sensor PCB bracket removal” on page 4-25.
12. Remove the three screws (A) from the waste toner auger chute.
A