Lexmark C950 - Sensor (Punch Carriage Shift HP) Removal

Repair information 4-325
5058-030
Go Back
Previous
Next
4. Release the hooks securing the sensor (media eject shaft HP) (A) to the bracket (C).
5. Remove the sensor (media eject shaft HP) (A).
Sensor (punch carriage shift HP) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
3. Remove the punch carriage assembly. See “Punch carriage assembly removal” on page 4-304.
4. Remove the one screw securing the bracket (A) to the punch carriage unit (B).
Rear
B
A
C
Connector