2-232 Service Manual
5058-030
Horizontal stripes (side to side direction)
7
Replace the transfer belt assembly. Go to “Transfer
belt assembly removal” on page 4-168.
Does the problem remain?
Go to step 8. Problem
resolved
8
Check the RIP card for proper connectivity.
Perform a print test. Go to “PRINT TESTS” on
page 3-22.
Does the problem remain?
Problem solved. Replace the RIP
PCBA.
Go to “RIP
PCBA removal”
on page 4-144.
Step Check Yes No
1 Check the media condition.
Load new, dry, recommended media.
Reprint the defective image.
Does the problem remain?
Go to step 2. Problem
resolved
2
Check the media transfer route.
Check the media route for contamination or obstacles.
Go to step 3. Remove
obstacles or
contamination.
3
Check the four PC cartridges for proper installation.
Check the PC cartridge connections.
Are the PC cartridge connections free of excess
wear and contamination?
Go to step 4. Correct and
clean
contaminated
pins, or replace
the appropriate
PC cartridge or
connector.
4
Check the 2nd transfer roller for contamination and
wear.
Is the 2nd transfer roller free of excess wear and
contamination?
Go to step 5. Replace the 2nd
transfer roller.
Go to “2nd
transfer roller
removal” on
page 4-24.
Step Check Yes No
Leading edge
Trailing edge
To Next Page
Loading...
