Repair information 4-285
5058-030
8. Remove the two screws securing the finisher docking bracket (D) to the printer.
9. Remove the finisher docking bracket (D).
Reinstallation note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.
Finisher right carriage belt removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
2. Remove the finisher front door assembly. See “Finisher front door assembly removal” on page 4-276.
3. Move the slip clutch gear 24T (A) toward the rear to disengage the stacker bin (B).
To Next Page
Loading...
