2-240 Service Manual
5058-030
Paper skew
The printed image is partially rotated as a result of the media not being fed straight into the device.
Step Check Yes No
1 Check printer installation placement.
Check the installation surface for irregularities.
Check for damaged printer caster.
Is the setup surface normal?
Go to step 2. Correct the
installation
placement.
2
Properly load media into the media tray assembly and
ensure all guides are set correctly.
Properly install the media tray assembly into the printer.
Reprint the defective image.
Does the problem remain?
Go to step 3. Problem
resolved
3
Check for obstructions in the area of the media feed
units.
Are the media feed unit assembly free from any
obstructions?
Go to step 4. Remove
obstructions.
4
Is the printer left door assembly properly and
evenly closed?
Go to step 5. Open, and then
properly close
the printer left
door assembly.
5
Check the 2nd transfer roller for contamination and
wear.
Is the 2nd transfer roller free of excess wear and
contamination?
Go to step 6. Replace the 2nd
transfer roller.
Go to “2nd
transfer roller
removal” on
page 4-24.
To Next Page
Loading...
