Lexmark C950 - Finisher Engine;Rip Functional Failure

Diagnostic information 2-221
5058-030
Go Back
Previous
Next
999.00 Finisher engine/RIP functional failure
3
POR the machine, and perform a
print test. Go to “PRINT TESTS”
on page 3-22.
Does the error continue?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-181.
Go to step 4.
Problem resolved
4
POR the machine, and perform a
print test. Go to “PRINT TESTS”
on page 3-22.
Does the error continue?
Replace the lower engine PCBA.
Go to “Lower engine PCBA
removal” on page 4-98.
Problem resolved
Step Action and questions Yes No
1 Turn the printer off and on
several times.
Does the error still occur when
the power is on?
Go to step 2. Problem resolved
2
Check the finisher PCBA
connections.
Are the connections of the
finisher controller card
assembly properly connected?
Replace the finisher PCBA.
Go to “Finisher PCBA removal”
on page 4-281.
Problem resolved
3
Check the upper printer engine
card assembly connections.
Are the connections of the
printer engine card assembly
properly connected?
Replace the upper printer engine
PCBA.
Go to “Upper printer engine
PCBA removal” on page 4-181.
Go to step 4.
Problem resolved
4
Check the lower printer engine
card assembly connections.
Are the connections of the
printer engine card assembly
properly connected?
Replace the lower engine PCBA.
Go to “Lower engine PCBA
removal” on page 4-98.
Go to step 5.
Problem resolved
5
Check the RIP card assembly
connections.
Are the connections of the RIP
card assembly properly
connected?
Replace the RIP card assembly.
Go to “RIP PCBA removal” on
page 4-144.
Problem resolved
Step Action and questions Yes No