Lexmark C950 - Stepper Motor (Entrance;Paddle) and Belt (Entrance;Paddle) Removal

4-346 Service Manual
5058-030
Go Back
Previous
Next
Reinstallation notes:
• The tension of the belt (buffer/transport) (D) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (C).
• Tighten the two screws in the order shown.
Stepper motor (entrance/paddle) and belt (entrance/paddle) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
2. Loosen the two screws securing the belt tensioner bracket (A) to the finisher and move upward, as shown.
3. Remove the belt (entrance/paddle) (B) from the stepper motor (entrance/paddle) (C).
E
B
Connector