4-154 Service Manual
5058-030
8. Disconnect the cable from the sensor (printer left duplex door interlock).
9. Release the four tabs securing the sensor (printer left duplex door interlock) to the bracket.
10. Remove the sensor (printer left duplex door interlock) from the bracket.
Sensor (printer left front door interlock) removal
1. Remove the printer front door. See “Printer front door removal” on page 4-10.
2. Remove the transfer belt cleaner. See “Transfer belt cleaner removal” on page 4-172.
3. Remove the waste toner box.
4. Remove the four photoconductor units.
5. Remove the four toner supplies.
6. Remove the operator panel front cover.
7. Remove the printhead retract door. See “Printhead retract door removal” on page 4-139.
8. Remove the inner cover. See “Inner cover removal” on page 4-3.
To Next Page
Loading...
