Lexmark C950 - Sensor (Stacker bin Upper Limit) or Sensor (Stacker bin no Media) Removal

4-332 Service Manual
5058-030
Go Back
Previous
Next
3. Disconnect the connector from the lift tray height sensor (stacker bin level R) (A).
4. Remove the screw securing the sensor (stacker bin level R) (A).
5. Remove the sensor (stacker bin level R) (A).
Sensor (stacker bin upper limit) or sensor (stacker bin no media) removal
1. Remove the rear upper cover. See “Rear upper cover removal” on page 4-309.
2. Remove the rear lower cover. See “Upper media bin front cover removal” on page 4-353.
3. Remove the stacker media bin assembly. See “High capacity feeder (HCF) removals” on page 4-359.
4. Remove the stacker bin lift motor assembly. See “Stacker bin lift motor assembly removal” on
page 4-337.
5. Remove the four screws securing the metal cover (A) to the finisher.
A
Rear
Connector