Lexmark C950 - Page 311

Diagnostic aids 3-15
5058-030
Go Back
Previous
Next
FINISHER TESTS
See “FINISHER TESTS” on page 3-18.
Staple Test
See “Staple Test” on page 3-18.
Hole Punch Test
See “Hole Punch Test” on page 3-18.
Feed Test
See “Feed Test (Finisher)” on page 3-18.
DEVICE TESTS
See “DEVICE TESTS” on page 3-16.
Quick Disk Test
See “Quick Disk Test” on page 3-16.
Disk Test/Clean
See “Disk Test/Clean” on page 3-16.
Flash Test
See “Flash Test” on page 3-16.
PRINTER SETUP
See “PRINTER SETUP” on page 3-22.
Defaults
See “U.S. / Non-U.S. Defaults” on page 3-23.
Prt Color Pg Count
See “Mono and Color Page Count” on page 3-22.
Prt Mono Pg Count
Perm Page Count
See “Permanent Page Count” on page 3-23.
Serial Number
See “Serial Number” on page 3-23.
Model Name
Configuration ID
See “Configuration ID” on page 3-22.
Reset Color Cal
See “Reset Color Calibration” on page 3-23.
Par 1 Strobe Adj
See “Parallel Strobe Adjustment (all parallel ports)” on
page 3-22.
REPORTS
See “REPORTS” on page 3-23.
Menu Settings Page
EVENT LOG
See “EVENT LOG (Diagnostics Menu)” on page 3-17.
Display Log
See “Display the Event Log” on page 3-17.
Print Log
See “Print the Event Log” on page 3-17.
Clear Log
See “Clear the Event Log” on page 3-17.
DEVELOPMENT MENU Do not use. For development use only.
Debug Port
Print History
ENGINE ADJUST
ATC Sensor Adjust Values
ATC Sensor Adjust Cycle
Finisher Config
Registration
EXIT DIAGS